Continuous discharge current (upper limit): 40A (if the cooling environment is not good, please reduce the load current use)
Continuous charge current (upper limit): 20A
Equalization version: suitable for starting current below 80A, power 135W below the drill.
Project
Min.
Typ.
Max.
Units
Consuming current
12
18
24
uA
Overcharged protection voltage
4.2
4.25
4.3
V
Balanced starting voltage
4.17
4.2
4.23
V
Equilibrium current
95
100
105
mA
Balanced heating power
1.56
1.72
1.91
W
Overcharge recovery voltage
4.1
4.15
4.2
V
Over-discharge protection voltage
2.4
2.5
2.6
V
Overvoltage protection after over-discharge protection
2.8
3
3.2
V
Overvoltage protection after over-discharge protection
3.2
3.5
3.8
V
Over-discharge recovery voltage
2.9
3.2
3.3
V
Conduction internal resistance
2.5
3
3.5
mQ
Overcurrent protection current C
70
80
90
A
Overcurrent delay time
100
150
200
ms
Continuous operating current
0
40
40
A
Continuous output power
0
672
672
W
Ambient temperature
-40
25
85
??C
Troubleshooting:
Fault phenomenon
Fault check and cause
The solution
Unable to charge
Measuring the voltage of 4 groups of batteries. when one of the battery voltages exceeds 4.25V, the protection board will activate overcharge protection.
Pair the battery pack well, do not mix the good battery and the bad battery.
Unable to discharge
Measuring the voltage of 4 groups of batteries. when one of the battery voltages is lower than 2.7V, the protection board will activate the over-discharge protection.
Pair the battery pack well, do not mix the good battery and the bad battery.
Charging/discharging failure
OV, 4.2V, S.4V, 12.6V, 16.8V miswired
Rewire or replace the new board (human failure, no warranty)
Overcharge/overdischarge failure
OV, 4.2V, 8.4V, 12.6V, 16.8V miswired
Rewire or replace the new board (human failure, no warranty)
Discharge protection
Check that the battery pack has sufficient discharge capability and check that the load’s starting current exceeds the overcurrent protection current of the protection board.
Replace the battery pack with a higher discharge capacity, or a protective plate with a larger current (super working range)
Component soldering
There is no connection between one of the components and the PCB pad.
Repair welding
Component welding
There is a short circuit between two or more pins of the component.
Remove the component and re-weld
Electrostatic breakdown A
In the unpowered state, measure the G, D, and S poles of the MOSFET. If the forward and reverse resistances of any two pins are 0Q, it indicates that it has broken down.
Remove the replacement MOS tube
Electrostatic breakdown B
Remove the MOS tube and measure the resistance of the G and D, G and S poles of the MOS tube. If there is a resistance indicating that it has broken down, the resistance should be infinite.
Be the first to review “4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board with Balance For Drill Motor 14.8V 16.8V Lipo Cell Module” Cancel reply
There are no reviews yet.